Open topic with navigation

Door Controllers

Editing a door controller
  1. Select Configuration > Hardware > X-Bus > Door Controllers.

  2. Click one of the blue marked data (for example, serial number).

  3. Configure the fields as described in the table below.
 

For naming and identifying:

In loop configuration, each expander is numbered consecutively from the first (expander connected to the 1A 1B on the controller) to the last (expander connected to the 2A 2B on the controller).

Example for SPC63xx: Expanders, when numbered 1 through 63, are allocated zones (in groupings of 8) in subsequent identities of 1 to 512 (the greatest number in zone identification is 512). Therefore, any expander named or identified by a number greater than 63 has no allocated zones.

 

Expander ID

ID of the door controller set with the rotary switches.

Type

Type of the door controller.

S/N

Serial number of the door controller.

Description

Description of the door controller.

Door I/O 1
  • If a door is assigned to the door I/O, select the corresponding door number. If the two inputs and outputs are configurable, select Zones/Outputs.
  • If a door number is selected for the door I/O, the door settings can be changed by clicking on the edit button. This is equal to Settings > Doors.
  • If Zones/Options is selected, the two zones and the one output can be configured by clicking the edit button.

Door I/O 2

Profile 1

For readers with a green and a red LED.

Profile 2

For VANDERBILT readers with a yellow LED (AR618X).

Profile 3

Profile 3 is used with HID readers that send a PIN to the panel as a card reading with a predefined site code (0 )

Profile 4

Profile 4 is used with HID readers that send a PIN to the panel as a card reading with a predefined site code (255 ).

Profile 5

Select to enable Sesam readers. It is also recommended that you select the Override Reader Profile option to provide feedback on the setting process.

Editing Zones/Outputs for a Door I/O

  1. Select a Zone/Output for the door I/O.
  2. Click the Edit button.
  3. The 2 inputs and the output belonging to this door I/O can be configured as normal door inputs and outputs. See Editing a door.
  4. In order to use the inputs, they have to be assigned to a zone number.