Seismic Test

To perform a seismic test:

1. Scroll to TEST > SEISMIC TEST.

2. Press SELECT.

3. Select TEST ALL AREAS, or select an individual area to test.

4. If you select an individual area to test, you can select either TEST ALL ZONES or select a specific seismic zone to test.

   The message ‘SEISMIC TEST’ is display on the keypad while the test is being performed.

   If the test fails, the message ‘SEISMIC FAIL’ is displayed. If the “i” or VIEW key is pressed, a list of the failed zones is displayed which can be scrolled through.

   If the test succeeds, ‘SEISMIC OK’ is displayed.

See also

Seismic Sensor Testing.