Description of the system alert.

The actual state of the alert that was detected on the panel (OK, Fault).

The programmed status of the system alert, that is, whether the alert has been isolated or inhibited. A status value of OK is displayed if the alert condition has not been disabled in any way.

Click this button to update the status of the system alerts.

Click this button to restore an alert on the panel

Click this button to inhibit a fault condition. The inhibit operation will disable that fault or zone for one arming period only.
Inhibit operation is not available in Security EN 50131 Grade 3.

Click this button to isolate the zone. Isolating a zone will de-activate that zone until such time as the zone is explicitly de-isolated again. It is recommended that you exercise caution when isolating zones as those zones will not be active every time the system is SET.