Open topic with navigation

Configuring wireless fob devices

If an 868MHz wireless receiver module is installed on the keypad or controller, a wireless fob device can be programmed via the keypad.

To program a wireless fob device on the system:

  1. Enter the Engineer Programming PIN. (Default PIN is 1111. See Engineer PINs.)
  2. Using the up/down arrow keys, scroll to the USERS option.
  3. Press SELECT.
  4. Select the EDIT option and press SELECT.
  5. Scroll to the preferred user and press SELECT.
  6. Scroll to the RF FOB option and press SELECT.

  7. Toggle the setting to ENABLED and press SELECT.

    The message PRESS KEY ON FOB flashes on the top line.

  8. Position the fob to within 8 meters of the keypad and press one of the keys.

    The message FOB CONFIGURED displays to indicate that the device has been registered.

To disable the wireless fob device on the system:

  1. Enter the Engineer Programming PIN. (Default PIN is 1111. See Engineer PINs.)
  2. Using the up/down arrow keys, scroll to the USERS option.
  3. Select the EDIT option and press SELECT.
  4. Scroll to the preferred user and press SELECT.
  5. Scroll to the RF FOB option and press SELECT.
  6. Toggle to DISABLED and press SAVE.
  If no 868MHz wireless receiver is detected on the system, the RF FOB option is not displayed in the keypad menu.

  Number of RF fobs per user: Only one fob device can be programmed for each user. To change fob devices among users, repeat the programming procedure for any new devices. Old fob devices become available for use by different users.