Open topic with navigation

Configuring the networking services of the panel

  1. Select Communications > Communications > Services.

  1. Configure the fields as described in the table below.

    HTTP Enabled

    Tick this box to enable the embedded web server on the panel.

    HTTP Port

    Enter the Port number that the web server is 'listening' on. By default this is set to 443.

    TLS Enabled

    Tick this box to enable encryption operation on embedded web server. By default this is enabled. With TLS enabled, web pages can only be accessed by using ‘https://’ prefix before typing the IP address.

    Telnet Enabled

    Tick this box to enable the Telnet server. (Default: Enabled)

    Note: Using Telnet without a comprehensive knowledge can damage the controller configuration; this should only be used if the user has sufficient knowledge or is being instructed by someone with such knowledge.

    Telnet Port

    Enter the number of the Telnet port.

    SNMP Enabled

    Tick this box to enable Simple Network Management Protocol (SNMP). (Default: Disabled)

    SNMP Community

    Enter the Community ID for the SNMP protocol. (Default : Public)

    ENMP Enabled

    Tick this box to enable Enhanced Network Management Protocol (ENMP). (Default : Enabled in Full Engineer)

    ENMP Port

    Enter the ENMP port number (default: 1287).

    ENMP password

    Enter the password for the ENMP protocol.

    ENMP change enabled

    Check this box to enable network changes to be made with ENMP protocol.