Multisite status

Product Version(s): SPC Connect 3.0, SPC Affinity, SPC Affinity CMS

Topic last updated: January 2020

The Multisite Status operation enables an installer or CMS operator to view a status summary for multiple sites at the same time. Different filter options allow the installer or operator to show only sites that exhibit certain faults or status (e.g. Comms Fault, Alarm, Engineer on Site).

The operation must be enabled for the relevant site group(s) (see below). Then, to use the operation, go to Operations > Multisite Operations, select a group of sites (All Sites/Favourite Sites/Site Group) with the operation enabled and navigate to the operation. The status for all of the selected sites is displayed in a table.

The Multisite Status operation supports:

  • Showing status summary for multiple sites in a company (Site Groups/All Sites/Favourite Sites).

  • Filtering and sorting of site status:

    • Comms Fault

    • Faults / Alerts

    • Alarms

    • Engineer on Site or Engineer Access Enabled

    • Unset / Fullset / Partset / Unknown

    • Search box for Keywords

  • Viewing in full-screen, auto-refresh mode (with manual pausing).

    Note: This functionality only available in SPC Affinity and CMS applications.

  • Accessing the System Summary page for individual sites.

Ensure that every site on which you want to use the operation is assigned to a site group, then enable the Multisite Status operation on the Operation Settings page for the relevant site group ( Configuration > Site Groups > Operation Settings ).

Ensure that each SPC panel in the site(s) uses the command profile Default Commands [SPC Connect] or a similar command profile.

An installer with access to the site group, and with the Multisite Status installer right enabled.